Page 1 of 1

Compilation Error EDC4015

PostPosted: Fri May 11, 2012 2:21 pm
by surime72
hi
i was trying to compile pli prog it was showing error as
DATA SET 'SYS1.SCSPLOAD' NOT IN CATALOG

DSNH740I ======= PLI FINISHED, RC = 4 ======= LISTING IN TEMP.LIST ===========
=================
DSNH740I ======= PRELINK FINISHED, RC = 4 ======= LISTING IN TEMP.SYSOUT.PRELL

WARNING EDC4015: Unresolved references are deteced:ted:
INFORMATIONAL EDC4013: No map displayed as no writable static was found.

Re: compilation error

PostPosted: Fri May 11, 2012 3:02 pm
by enrico-sorichetti
DATA SET 'SYS1.SCSPLOAD' NOT IN CATALOG

what is that You do not understand in the message
a dataset referenced in Your compilation procedure was not found AMEN

nobody on the forum belongs to Your organization,
so.... nobody knows about Your installation naming standards
products installed and ... ... ...

the best and only place to ask is Your support
whose job is also to provide properly tested compilation procedures.

the messages are warning and information
check to see if something has/can be done to get rid of them

Re: compilation error

PostPosted: Fri May 11, 2012 5:03 pm
by surime72
hi
we are not using jcl as a compilation.i was new for the comiplation of this way so iwas facing error as IEW2735S DA0F OUTPUT DATA SET FOR DDNAME SYS00244 HAS INVALID RECORD FORMAT.
RECFM=U IS REQUIRED.
DSNH740I ======= LINK FINISHED, RC = 12 ======= LISTING IN TEMP.LINKLIST =====
=======================
DSNH759I DSNH TERMINATING, LINK RC = 12

Re: compilation error

PostPosted: Fri May 11, 2012 5:09 pm
by Robert Sample
Even though you are not using JCL for a compile, you still MUST talk to someone AT YOUR SITE about the error messages you are receving. Nobody on this forum can possibly help you, since each site can cusotmize compile procedures (both TSO and batch) and there is no way anybody not working at your site could possibly know how your site customized things.