UDS2000 utility program
Posted: Tue Jul 21, 2009 2:06 pmHi Frds,
did any body know what the UDS2000 utility program used for.
let me know your comments.
did any body know what the UDS2000 utility program used for.
let me know your comments.
IBM Mainframe Forum
Mainframe Technical Support Forums
https://www.ibmmainframeforum.com/
UDS2000 utility program
Page 1 of 1
Posted: Tue Jul 21, 2009 2:06 pmRe: UDS2000 utility program
Posted: Tue Jul 21, 2009 3:57 pmI think it is used for setting user defined default specifications to the prevailing GDDM values.
Re: UDS2000 utility program
Posted: Wed Jul 22, 2009 1:30 amHello and welcome to the forum,
Where did you hear of this utility?
Did you ask whoever supports the job where it is run?
Where did you hear of this utility?
Did you ask whoever supports the job where it is run?
Re: UDS2000 utility program
Posted: Wed Jul 22, 2009 2:01 amMust be important. I've seen this question posted on at least three different forums. 
Re: UDS2000 utility program
Posted: Tue Jul 28, 2009 6:03 pmYour question is site specific. Unless, for the purpose I'd been using UDS2000 at my shop -- my answer would be useless. Suggest, you look into the documentation of the PROC(s) in which this program is called.
Just for a note -- usually, in a crude sense, whenever there is a need of balancing between interfacing systems this program is used under the heading "UNITECH AUTOMATED CONTROL". So it's a program used for Unitech Procedures. It's a copyright material if you need further information get in touch with Unitech Support people at your shop or the people who support this there.
Hope this helps.
Just for a note -- usually, in a crude sense, whenever there is a need of balancing between interfacing systems this program is used under the heading "UNITECH AUTOMATED CONTROL". So it's a program used for Unitech Procedures. It's a copyright material if you need further information get in touch with Unitech Support people at your shop or the people who support this there.
Hope this helps.