Page 1 of 1

Spool commands

PostPosted: Thu Jun 14, 2012 11:12 pm
by suresh_pachwa
1). What will happen if we give 'D' infront of job in spool when the job is in execution.

2). What will happen if we give 'D' infront of job in spool for completed job.

Re: Spool commands

PostPosted: Thu Jun 14, 2012 11:20 pm
by enrico-sorichetti
what happened when You tried,
or when You did ( because You did ) read the manual or press the pf1 ( help ) key ?

Re: Spool commands

PostPosted: Thu Jun 14, 2012 11:26 pm
by suresh_pachwa
When i tried for completed job it shows as command issued....

but i didn't get what action it took...

Re: Spool commands

PostPosted: Thu Jun 14, 2012 11:42 pm
by dick scherrer
Hello and welcome to the forum,

After you issued the 'D' command on the completed job what happened?

Was the job still in the spool?

Re: Spool commands

PostPosted: Fri Jun 15, 2012 1:50 am
by NicC
What are you using to access the spool? SDSF? What were you hoping to achieve by issuing the D command?

Re: Spool commands

PostPosted: Mon Jun 18, 2012 7:50 pm
by Anuj Dhawan
From the manuals, under SDSF, D implies to the following:

D     Display job information in the log. You can add:     
      E    - Line, page, record, and card counts (JES3 only)
      L    - Long form (JES2 only)                         
      M    - Mains on which the job is eligible             
             to run (JES3 only)                             
      MA   - MDS allocate queue information (JES3 only)     
      ME   - MDS error queue information (JES3 only)       
      MR   - MDS restart queue information (JES3 only)     
      MSS  - MDS system select queue information (JES3 only)
      MSV  - MDS system verify queue information (JES3 only)
      MU   - MDS unavailable volumes information (JES3 only)
      SD   - DDNAMEs of all spool data sets that contain data
             (JES3 only)                                     
      SH   - DDNAMEs of data sets in spool hold status that 
             contain data (JES3 only)                       
      SP   - Spool partition name (JES3 only)               
      X    - Extended (JES3 only)