Page 2 of 2
Re: Pass Dynamic value to SYSIN card while executing SQLs
Posted:
Thu Feb 27, 2014 10:35 pm
by dick scherrer
Thanks Peter.
I mis-spoke earlier . . . Not sure where i came up with 1.13 . . .
d
Re: Pass Dynamic value to SYSIN card while executing SQLs
Posted:
Thu Feb 27, 2014 11:30 pm
by Peter_Mann
Your welcome, and NP, I myself was thinking there was some support for symbols in 1.13 also.
Re: Pass Dynamic value to SYSIN card while executing SQLs
Posted:
Fri Feb 28, 2014 11:45 am
by shankar_dh
Thank you all for the discussion and letting us know the things.
So at last, we can not pass symbolic value to SYSIN data??
No other alternatives??
Re: Pass Dynamic value to SYSIN card while executing SQLs
Posted:
Fri Feb 28, 2014 2:28 pm
by Blackthorn
Yes, the other alternative is what Nic suggested in the second post -
"Otherwise you need to have a program read a parameter defined by a symbolic and generate your query in a previous step."
Re: Pass Dynamic value to SYSIN card while executing SQLs
Posted:
Fri Feb 28, 2014 2:33 pm
by NicC
Blackthorn wrote:Yes, the other alternative is what Nic suggested in the second post -
"Otherwise you need to have a program read a parameter defined by a symbolic and generate your query in a previous step."
A topic that has been discussed before in the forum probably most often in the Sort sections.