Page 2 of 2

Re: Can't Startup CICS region

PostPosted: Mon Nov 26, 2012 11:49 pm
by Robert Sample
I did not say the ONLY way is to find the JCL being executed in the console START command, but that is the easiest way. I cannot tell you how to look at this JCL, since it depends upon whether or not your TSO user id has the appropriate RACF authority to view the JCL. Only by contacting the contest moderators can you find out for sure. And since it is not likely that anyone on this forum is a contest moderator, your chances of getting viable help on this forum are very close to zero.

Re: Can't Startup CICS region

PostPosted: Tue Nov 27, 2012 12:19 am
by chest33r
Well, thanks for your fast and great support :)

Re: Can't Startup CICS region

PostPosted: Tue Nov 27, 2012 12:55 am
by Robert Sample
There are several others on this forum that are participating in the contest as well. Perhaps you'll be lucky and one of them will provide you the data set name you need to create.

Re: Can't Startup CICS region

PostPosted: Tue Nov 27, 2012 4:27 am
by chest33r
Looking at this post I found some lines of code where DFHRPL appears. Don't know if it's ok because he said he's writing his own CICS startup JCL and tried to code it like that.

//DFHRPL   DD DSN=CICSTS.CICS660.SDFHLOAD,DISP=SHR
//         DD DSN=CICSTS.CICS660.SDFHAUTH,DISP=SHR
//         DD DSN=CICSTS.CICS660.SDFJAUTH,DISP=SHR
//         DD DSN=CEE.SCEECICS,DISP=SHR             
//         DD DSN=CEE.SCEERUN2,DISP=SHR             
//         DD DSN=CEE.SCEERUN,DISP=SHR             


But all of them are already allocated, I think I must create a new one that doesn't exists...

Re: Can't Startup CICS region

PostPosted: Tue Nov 27, 2012 11:50 am
by jaggz
Hi,

Referring CICS installation guide would be a good thing to understand the whole Installation.

Jaggz

Re: Can't Startup CICS region

PostPosted: Tue Nov 27, 2012 6:32 pm
by chest33r
Ok, thanks Jaggz.