Page 1 of 1

Auto Install

PostPosted: Thu Mar 21, 2013 11:30 pm
by freelar
Auto Install is setup but we're going to turn it off, a higher authority is making us, so writing SARBCH/Easytrieve to get the DFHPG0209 auto install messages.

I've gone through 3 CICS regions so far with a lot of auto install messages for PPT entries that already exist.

These messages aren't showing because of the applications but are showing on outside processing accessing data through the application programs/maps.

Why would auto install show up for PPT entries that exist?

Thanks, Rickey

Re: Auto Install

PostPosted: Fri Mar 22, 2013 7:06 pm
by freelar
We have about 8 CICS regions for production:

DFHPG0209 Auto Install message in a TOR CICS region.
CICSPRD CPLT PPT entry for HBR$CMDP has been autoinstalled using model DFHPGAPG
This application is host bridge using HBR* programs to get data from an application and load into a distributed system.
These auto install messages are happening on processes that uses data of other applications, Hostbridge, P360, Macros
The program HBR$CMPD is defined in the TOR T150 and in the AOR where it goes to get data using the data applications maps and programs