Page 1 of 1
What to do when APC3?
Posted:
Wed May 01, 2013 12:30 am
by michel123
Hello,
What to do when APC3?
I defined as the Map, the program and the transaction under CEDA.
Thank you.
Re: What to do when APC3?
Posted:
Wed May 01, 2013 12:53 am
by enrico-sorichetti
speak to Your support!
Re: What to do when APC3?
Posted:
Wed May 01, 2013 2:43 am
by Robert Sample
Have you followed the advice in the manual?
APC3
Explanation:
An attempt to run the program has failed because CICS has identified the program as 'Language Environment enabled' but Language Environment support is not present in the system.
System action:
The transaction is abnormally terminated and the program is disabled.
User response:
Refer to messages issued during CICS initialization to determine why Language Environment is not present in the system.
Modules:
DFHAPLI
Re: What to do when APC3?
Posted:
Wed May 01, 2013 3:28 am
by michel123
Thank you to you.
This message is present in SYSLOG :
0090 +DFHAP1203I CICS Language Environment is being initialized.
0090 +DFHAP1200 CICS A CICS request to the Language Environment has failed.
Reason code '0011020'.
0090 +DFHAP1208 CICS Language Environment cannot support the Cobol language.
0090 +DFHAP1209 CICS Language Environment cannot support the C/C++ languages.
0090 +DFHAP1210 CICS Language Environment cannot support the PL/I language.
My program is written in COBOL.
I will report this to the management system.
Re: What to do when APC3?
Posted:
Wed May 01, 2013 3:53 am
by Robert Sample
With the additional messages, it appears that this
http://www-01.ibm.com/support/docview.w ... wg21198205 could be your problem -- at least the messages match.
Re: What to do when APC3?
Posted:
Wed May 01, 2013 1:42 pm
by michel123
Hello robert,
Yes, effectively, the messages are the same.
One of our responsible is already looking this problem.
Re: What to do when APC3?
Posted:
Wed May 01, 2013 2:00 pm
by enrico-sorichetti
unless the CICS being used is a new CICS <image>
the messages received are very confusing