Page 1 of 1

3.4 SAVE command

PostPosted: Wed Feb 09, 2011 9:23 pm
by Unshriven
I am trying to save a list of a certain HLQ in 3.4 which I've done successfully. However, it also saves the catalog attributes. I'm wondering if there is a way I can save a list of datasets in 3.4 but have only the names saved. Any help would be appreciated.

Re: 3.4 SAVE command

PostPosted: Wed Feb 09, 2011 10:10 pm
by enrico-sorichetti
NO!

Re: 3.4 SAVE command

PostPosted: Thu Feb 10, 2011 12:54 am
by dick scherrer
Hello,

Once saved, change everything other than the name(s) to spaces. . .

Re: 3.4 SAVE command

PostPosted: Tue Feb 15, 2011 7:35 pm
by Unshriven
Thanks for the replies. I was hoping to not have to go back and edit out the attributes manually but that seems like what I'm going to have to do.

Re: 3.4 SAVE command

PostPosted: Wed Feb 16, 2011 1:51 am
by NicC
It is ONE command - Change p'¬' ' ' all colx coly

Look up picture strings in Change/Find command.

Alternatively set the left bound to the right of the dataset names and shift the rest of the data to the right as many columns as needed to drop the data off the end of the lines

Re: 3.4 SAVE command

PostPosted: Wed Feb 16, 2011 6:27 am
by Unshriven
NicC wrote:It is ONE command - Change p'¬' ' ' all colx coly

Look up picture strings in Change/Find command.

Alternatively set the left bound to the right of the dataset names and shift the rest of the data to the right as many columns as needed to drop the data off the end of the lines


Thanks Nic, I'll give it a try