Page 2 of 2

Re: Send email through mainframe

PostPosted: Thu Jul 17, 2008 1:12 am
by dick scherrer
Hello Nazish and welcome to the forums,

I have tried sending emails through JCL
You need to post the jcl you used and all of the diagnostic/information output from the run. When you post jcl and control info, use the "Code" tag on the top of the reply panel. This will preserve alignment and use a fixed font for readability.

You should probably also talk with your system/network admin people and make sure this is permitted on your system - not every system allows sending e-mails. The destination you sent to may also discard incoming e-mail from untrusted sources.

Re: Send email through mainframe

PostPosted: Fri Jul 18, 2008 12:21 am
by dick scherrer
Hello,

I have tried sending emails through JCL.
For someone to help, you need to post what you are having problems with. . .

Re: Send email through mainframe

PostPosted: Sun Jul 20, 2008 3:38 am
by dick scherrer
Hello,

Can any one give me more information?
You need to post all of the jcl and control info you used in the step.

You also need to post any information presented by the step - even if it does not seem to be e-mail related.