Page 1 of 1

Volume need to make it go offline.

PostPosted: Sun Apr 04, 2010 2:24 pm
by Bad Man
Hi I have a volume in F-NRD status and I am trying to reformat it but it keeps asking for the device which is offile.
Can some one please let me know. I tried varying it offline again but to no use.

Re: Volume need to make it go offline.

PostPosted: Sun Apr 04, 2010 6:29 pm
by Robert Sample
What command are you using to vary the volume offline?

Re: Volume need to make it go offline.

PostPosted: Mon Apr 05, 2010 4:52 pm
by Bad Man
vary ucbb,offline

Two weeeks back I gave on some other system \vary ucbb,offline,force and the devices went in to box yipessss I then gave \vary ucbb,online,uncond and the device came back...

Re: Volume need to make it go offline.

PostPosted: Mon Apr 05, 2010 9:08 pm
by Robert Sample
If the volume is shared between LPAR's, you would have to issue vary ucbb,offline,all to get it offline to every LPAR.

Re: Volume need to make it go offline.

PostPosted: Mon Apr 05, 2010 11:09 pm
by Bad Man
It says force expected before all.........

Re: Volume need to make it go offline.

PostPosted: Mon Apr 05, 2010 11:44 pm
by Robert Sample
So what happened when you put "force" before "all"?

Re: Volume need to make it go offline.

PostPosted: Mon Apr 05, 2010 11:52 pm
by Robert Sample
And while I'm thinking about it, are you running JES2 or JES3? When using the VARY command, the difference is extremely important.

Re: Volume need to make it go offline.

PostPosted: Mon Apr 05, 2010 11:54 pm
by Bad Man
It is JES2 using RACF or ZEKE.

Re: Volume need to make it go offline.

PostPosted: Mon Apr 12, 2010 6:56 pm
by stefkrastev
Hello Bad man!
If after V ucbb,OFFLINE you are receiving IEF524I ucbb, VOLUME PRDxxx PENDING OFFLINE – you should issue d ios,config to see the name of your sys1.iodfxx – then go with HC for sys1.iodfxx – 1 (view) – 5 (I/O device) - /ucbb – 8 (view) – etc. until view the parameter OFFLINE YES or NO for this ucbb. The reason is here – if your ucbb is OFFLINE NO, it means that during IPL it is set always to ONLINE. Ask your IPL support to change this parameter to parameter OFFLINE YES and reIPL. Then you will have V ucbb,OFFLINE OK.
Hope this will help!

Re: Volume need to make it go offline.

PostPosted: Sat Apr 17, 2010 9:29 pm
by Bad Man
ohhhh Man...I had coded in MY jcl a DD statement ponitng to a VOLSER=XXXXXX and that was the problem got rid of the DD as t was not needed and the DASD was reformatted eventhough the volume was F-NRD on some Lpar's.

Also I tried hitting offline after going to each Lpar but the volume remained in F-NRD...