Hi, i wanted to know what leadtime and QTM stand for, and what are they used for.
Also, how can I know the lookback time ca7 uses to check requirements for a specific triggered job?
Thanks.
QTM, LEADTIME and Lookback
-
royalfield
- Posts: 1
- Joined: Tue May 26, 2009 5:50 am
- Skillset: ca7 - jcl
- Referer: google
-
dick scherrer
- Global moderator
- Posts: 6268
- Joined: Sat Jun 09, 2007 8:58 am
Re: QTM, LEADTIME and Lookback
Hello and welcome to the forum,
Suggest you read about these in the documentation. There is no reason for people here to do the reading for you.
If you find something that is not clear, post what you found and your doubt about it.
Someone here may be able to clarify.
Suggest you read about these in the documentation. There is no reason for people here to do the reading for you.
If you find something that is not clear, post what you found and your doubt about it.
Someone here may be able to clarify.
Hope this helps,
d.sch.
d.sch.