Page 1 of 1
Would like to know how Endevor would be used
Posted: Thu Sep 18, 2008 9:56 pm
by varsha
I would like to know how Endevor would be used.
Re: Would like to know how Endevor would be used
Posted: Fri Sep 19, 2008 12:42 am
by dick scherrer
Hello varsha and welcome to the forums,
CA-Endevor is change management software.
For more info, look here:
http://www.ca.com/us/products/product.aspx?id=259
Re: Would like to know how Endevor would be used
Posted: Fri Sep 19, 2008 2:23 am
by varsha
Hello Dick,
Thanks a lot for the information.
Re: Would like to know how Endevor would be used
Posted: Fri Sep 19, 2008 2:35 am
by dick scherrer
You're welcome
d
I want to know how multiple program can compiled in endevor
Posted: Thu Mar 30, 2017 2:25 pm
by rakeshsneha1212
Hi All,
I am working on a request, were mulptiple program to be compiled in endeavor because of a copy book change. Is there any way i can achieve this this will reduce lot of manual work.
Re: Would like to know how Endevor would be used
Posted: Thu Mar 30, 2017 3:33 pm
by prino
And so you open a nearly nine year old thread that has fluck all to do with your question?
How about you read the flucking manuals, rather than waste time here?
SIASD!!!
Re: Would like to know how Endevor would be used
Posted: Thu Mar 30, 2017 5:11 pm
by enrico-sorichetti
I am working on a request, were mulptiple program to be compiled in endeavor because of a copy book change. Is there any way i can achieve this this will reduce lot of manual work.
if endevor ( or any scm ) has been properly setup a change in a dependency ( a copy book in this case ) will cause a rebuild of ALL the programs using it
naturally the syntax and the commands to achieve the above will change.