Page 2 of 2
Re: Typrun=scan Where i need to see the errors
Posted:
Sat Dec 10, 2011 2:29 pm
by BillyBoyo
You will see any errors in the list output from the Job.
Re: Typrun=scan Where i need to see the errors
Posted:
Sat Dec 10, 2011 2:39 pm
by mainframemunic
ya i have seen the errors in the spool area. it shows jcl error.....
Re: Typrun=scan Where i need to see the errors
Posted:
Sat Dec 10, 2011 3:33 pm
by Anuj Dhawan
I'm on a toss and confused - at the start of this thread you (OP) said that you are not able to see the "errors" and now all of sudden you are able to see errors - so are you good now?
Re: Typrun=scan Where i need to see the errors
Posted:
Sun Dec 11, 2011 6:13 am
by dick scherrer
Hello,
ya i have seen the errors in the spool area. it shows jcl error.....
That's a start. . .
The actual error is also presented for you to use correcting the error(s). Have you done this?