Page 4 of 4

Re: How to pass input from Rexx to JCL

PostPosted: Sat Mar 30, 2013 3:55 pm
by Quasar
Enrico,

Yeah, I just felt you went over the board, to explain that one and yet... Plus you gave a pure batch-only solution. She should figure it out then!

- Quasar

Re: How to pass input from Rexx to JCL

PostPosted: Mon Apr 01, 2013 2:46 pm
by Sonal C
Hello Enrico Sir,

As you told I tried to run snippet given by you. It worked for me.

Now I am using that as a template and modifying it according to my requirement.

Quasar,

I am very much new to REXX. I was trying to figure out my requirements according to my understanding. I didnt new that running PANEL in BATCH should not be done.

I am in learning phase sir, that's why I have posted my questions here.

Anyways thanks for helping me. I hope I will not waste your time anymore.

Regards,
Sonal

Re: How to pass input from Rexx to JCL

PostPosted: Mon Apr 01, 2013 5:08 pm
by Quasar
Sonal,

Oh no, you aren't! You have a question, you're stuck up, you need an approach/solution, you should definitely write to a forum.

I am in learning phase sir, that's why I have posted my questions here.


As you've said, you have the love of learning. Some here have the love of learners. And a forum brings these loves together! But, one should do plenty of research, for example google the term "File Tailoring Skeletons", read the IBM manuals, search this forum for any similar posts, before making a new post. This forum is searcheable.Your post should crisp, concise and extremely clear. Further, ask the right questions. Don't regress over them.

I hope that's encouraging.

Thank you very much.