Page 1 of 1
UDS2000 utility program
Posted:
Tue Jul 21, 2009 2:06 pm
by spallaga
Hi Frds,
did any body know what the UDS2000 utility program used for.
let me know your comments.
Re: UDS2000 utility program
Posted:
Tue Jul 21, 2009 3:57 pm
by nayanpatra
I think it is used for setting user defined default specifications to the prevailing GDDM values.
Re: UDS2000 utility program
Posted:
Wed Jul 22, 2009 1:30 am
by dick scherrer
Hello and welcome to the forum,
Where did you hear of this utility?
Did you ask whoever supports the job where it is run?
Re: UDS2000 utility program
Posted:
Wed Jul 22, 2009 2:01 am
by MrSpock
Must be important. I've seen this question posted on at least three different forums.
Re: UDS2000 utility program
Posted:
Tue Jul 28, 2009 6:03 pm
by Anuj Dhawan
Your question is site specific. Unless, for the purpose I'd been using UDS2000 at my shop -- my answer would be useless. Suggest, you look into the documentation of the PROC(s) in which this program is called.
Just for a note -- usually, in a crude sense, whenever there is a need of balancing between interfacing systems this program is used under the heading "UNITECH AUTOMATED CONTROL". So it's a program used for Unitech Procedures. It's a copyright material if you need further information get in touch with Unitech Support people at your shop or the people who support this there.
Hope this helps.