JCL typrun=scan tnen, Max-RC=0000 Not blank



JES, JES2, JCL utilities, IDCAMS, Compile & Run JCLs, PROCs etc...

JCL typrun=scan tnen, Max-RC=0000 Not blank

Postby stan01 » Thu Apr 28, 2011 2:37 pm

Dear Support,
I have a question for SDSF Max-RC field.
I try a JCL with TYPRUN=SCAN, then JCL is DUMMY JOB(for IEFBR14).
In z/OS v1.4 and v1.8 , then TYPRUN=SCAN JCL completed and SDSF MAX-RC field is blank.
But in z/OS v1.11, I find TYPRUN=SCAN completed and SDSF MAX-RC field is CC-0000.
.
Please kindly give me some suggestion for this situation. thanks.
z/OS V1.8
SDSF OUTPUT ALL CLASSES ALL FORMS
JOBNAME Max-RC
ZTWSDUMY ------> this is blank
.
z/OS V1.11
SDSF OUTPUT ALL CLASSES ALL FORMS
JOBNAME Max-RC
ZTWSDUMY CC-0000 ------> this is 0000
--------------------------------------------------------
Whar reason occur this problem? thanks.
.
Stan Yang
stan01
 
Posts: 8
Joined: Sat Aug 07, 2010 11:35 am
Has thanked: 0 time
Been thanked: 0 time

Re: JCL typrun=scan tnen, Max-RC=0000 Not blank

Postby Robert Sample » Thu Apr 28, 2011 2:45 pm

This is not a problem -- it is a change in system behavior, which happens every release of z/OS. YOU may have an issue with it, but IBM probably told you all about the change in the manual. I recommend you read the SDSF manual and verify this. Once it has been verified, be aware that there may be no way to change the behavior -- IBM made the change for a good reason so they are not likely to undo the change just because you don't like it.

RTFM.
Robert Sample
Global moderator
 
Posts: 3720
Joined: Sat Dec 19, 2009 8:32 pm
Location: Dubuque, Iowa, USA
Has thanked: 1 time
Been thanked: 279 times

Re: JCL typrun=scan tnen, Max-RC=0000 Not blank

Postby stan01 » Thu Apr 28, 2011 9:33 pm

Dear support:
Thanks many again.
It is fine for your response. and I will to read SDSF paper. thanks.
I think I need to find what release version for z/OS change this behavior. thanks.
.
Stan Yang.
stan01
 
Posts: 8
Joined: Sat Aug 07, 2010 11:35 am
Has thanked: 0 time
Been thanked: 0 time

Re: JCL typrun=scan tnen, Max-RC=0000 Not blank

Postby stan01 » Tue May 03, 2011 10:51 pm

Dear All:
Have any one know what release for JES2 or SDSF version to change this situation?
or have any JES2 parameter to control this situation?
that is have any parameter to reset to ori situation?
I try to check JES2 manual and SDSF manual , but it is Not find any message.
Please give me some suggestion or advise. Thanks.
Stan.
stan01
 
Posts: 8
Joined: Sat Aug 07, 2010 11:35 am
Has thanked: 0 time
Been thanked: 0 time


Return to JCL

 


  • Related topics
    Replies
    Views
    Last post