Page 1 of 1

Extract SDSF output from held queue

PostPosted: Tue Nov 16, 2010 1:37 pm
by p19689
Hi, I tried to save the output from SDSF held queue to a dataset and 'E' from command column and it worked and allowed me to allocate a dataset and save the job output. But when I tried in diffeent LPAR (obvioulsly it has different JES system) it does not respond to 'E' or 'XE' . But when I 'SE' it gave a browse mode. How should I save the output into dataset please. Thanks for your help.

Re: Extract SDSF output from held queue

PostPosted: Tue Nov 16, 2010 3:32 pm
by p19689
Hi, I found the command to extract , It's 'XDC' .
Can someone please tell how to identify which JES system install in your system (JES2 or JES3) ?

Re: Extract SDSF output from held queue

PostPosted: Tue Nov 16, 2010 3:46 pm
by Robert Sample
Can someone please tell how to identify which JES system install in your system (JES2 or JES3) ?
1. Ask your site support group -- by far the most preferred answer (not just to this question, either).
2. Look at any batch job output -- the JES subsystem is identified on every job.

Re: Extract SDSF output from held queue

PostPosted: Tue Nov 16, 2010 6:33 pm
by p19689
Thanks, We have JES2 and JES3 both in differnt LPARS. That's probably why some SDSF commads are not compatible.