Page 1 of 1
CA7 - trigger a recovery job when i get jclerror or rc=12
Posted:
Fri May 06, 2016 2:47 pm
by mpizzicheria
Hi
i have to trigger a recovery job "B" when the job "A" is in error (jcl error or rc > 4)
is it possible make it?
thanks
mauro
Re: CA7 - trigger a recovery job when i get jclerror or rc=
Posted:
Fri May 06, 2016 3:34 pm
by NicC
is it possible make it?
If you meant:
is it possible do this?
then the answer is "Yes".
To your follow-up question (How do I do this?) you speak to you scheduling group.
Re: CA7 - trigger a recovery job when i get jclerror or rc=
Posted:
Fri May 06, 2016 3:46 pm
by mpizzicheria
ok i have a chain:
A
B
C
if job B is in KO i have to run JOB B1 (recovery job) and after when B1 is ended execute C
reagards
mauro
Re: CA7 - trigger a recovery job when i get jclerror or rc=
Posted:
Fri May 06, 2016 7:20 pm
by Akatsukami
Good for you. Now, as NicC said. go to your scheduling workgroup and tell them of your requirement.