Page 1 of 1

Would like to know how Endevor would be used

PostPosted: Thu Sep 18, 2008 9:56 pm
by varsha
I would like to know how Endevor would be used.

Re: Would like to know how Endevor would be used

PostPosted: Fri Sep 19, 2008 12:42 am
by dick scherrer
Hello varsha and welcome to the forums,

CA-Endevor is change management software.

For more info, look here:
http://www.ca.com/us/products/product.aspx?id=259

Re: Would like to know how Endevor would be used

PostPosted: Fri Sep 19, 2008 2:23 am
by varsha
Hello Dick,

Thanks a lot for the information.

Re: Would like to know how Endevor would be used

PostPosted: Fri Sep 19, 2008 2:35 am
by dick scherrer
You're welcome :)

d

I want to know how multiple program can compiled in endevor

PostPosted: Thu Mar 30, 2017 2:25 pm
by rakeshsneha1212
Hi All,

I am working on a request, were mulptiple program to be compiled in endeavor because of a copy book change. Is there any way i can achieve this this will reduce lot of manual work.

Re: Would like to know how Endevor would be used

PostPosted: Thu Mar 30, 2017 3:33 pm
by prino
And so you open a nearly nine year old thread that has fluck all to do with your question?

How about you read the flucking manuals, rather than waste time here?

SIASD!!!

Re: Would like to know how Endevor would be used

PostPosted: Thu Mar 30, 2017 5:11 pm
by enrico-sorichetti
I am working on a request, were mulptiple program to be compiled in endeavor because of a copy book change. Is there any way i can achieve this this will reduce lot of manual work.


if endevor ( or any scm ) has been properly setup a change in a dependency ( a copy book in this case ) will cause a rebuild of ALL the programs using it
naturally the syntax and the commands to achieve the above will change.