Re: ED Instruction and Edit Masks
Posted:
Mon Aug 19, 2013 11:10 am
by bobguo
00000 85 HEXTAB EQU *-C'0'
0000F0 F0F1F2F3F4F5F6F7 86 DC C'0123456789ABCDEF'
HEXTAB DC C'0123456789ABCDEF'
what's the differences between them?
Re: ED Instruction and Edit Masks
Posted:
Wed Aug 21, 2013 9:56 am
by bobguo
00007E 0007E 000F0 18 ORG MAIN+C'0'
0000F0 000F0 000F0 19 ORG ,
the last question:
what's the value of the memory from 00007E to 0000F0?
can we access it? (i think i have the answer to it, keep on using ORG to relocate location counter).
thanks.
Re: ED Instruction and Edit Masks
Posted:
Tue Aug 27, 2013 10:27 am
by bobguo
though i have caught what this program's general purpose, but as one HLASM beginner, i don't know how to check its result.
under jes2, i can't see anything about it, or can somebody tell me how to refer to the message, which appeared on the terminal, sent by TPUT?
thanks.
Re: ED Instruction and Edit Masks
Posted:
Tue Aug 27, 2013 11:32 am
by bobguo
another one similar question, if i issued
WTO 'HELLO WORLD'
in the HLASM program, where can i find 'HELLO WORLD' appeared?
Re: ED Instruction and Edit Masks
Posted:
Tue Aug 27, 2013 3:08 pm
by steve-myers
under jes2, i can't see anything about it, or can somebody tell me how to refer to the message, which appeared on the terminal, sent by TPUT?
The TSO terminal operator running the program. The TPUT macro is the lowest level macro that a program running in the TSO environment can use to display output at the terminal of the TSO user running the program. A TPUT macro issued by a batch program will not display anywhere.
WTO 'HELLO WORLD'
in the HLASM program, where can i find 'HELLO WORLD' appeared?
- In the JES2 JESMSGLG data set for the JES2 job running the program that issued the WTO macro.
- In the SYSLOG data set for the system where the job was run.