I know there is a TSO command to send a dataset to a certain printer like this
PL datasetname printername
(I think PL means "print landscape").
Is there a similar way to send held job output to a specific printer?
send job output to specific printer
-
Tzadik Vanderhoof
- Posts: 21
- Joined: Tue Nov 13, 2007 11:53 pm
- Skillset: I received an email that i have been registered and approved but the username and password you sent me are not working. I tried to find a way to contact you but I was not able to, and the email says "donotreply".
- Referer: web search
-
dick scherrer
- Global moderator
- Posts: 6268
- Joined: Sat Jun 09, 2007 8:58 am
Re: send job output to specific printer
Hello,
I believe PL is site-specific - rather than part of the IBM standard release.
Ask your system support people for the printer-id(s) of the printers you can route output to.
When you look at output in the held output queue, you can modify the output to be printed and the destination where it should print.
You might also ask your support people if there are any (other) short-cut commands available to you.
I believe PL is site-specific - rather than part of the IBM standard release.
Ask your system support people for the printer-id(s) of the printers you can route output to.
When you look at output in the held output queue, you can modify the output to be printed and the destination where it should print.
You might also ask your support people if there are any (other) short-cut commands available to you.
Hope this helps,
d.sch.
d.sch.