Ask queries about other IBM Tools like Tivoli, COBTEST, Fault Analyzer, z/OS File Manager, Workload Simulator, APA, SCLM, Merge & Migration Tools etc...
by Karthik_v » Thu Sep 29, 2011 6:35 pm
Hi All,
I have the below requirement
I have to write one Program Interface(PIF) that takes TWS operation (job) name as input
and searches for that operation(job) in all Applications that exists in
TWS data base AD .It should give a return code zero if the job exists in any of the Applications
I searched Program Interfaces document in that for ADOP Segment I see
ADOPJN as parameter for jobname. But I dont see the segment ADOP listed under LIST or SELECT Action code
Could you please advise under which Action code I need to use ADOP segment to get the required result ?.Thanks
-
Karthik_v
-
- Posts: 1
- Joined: Sun Sep 04, 2011 5:24 pm
- Has thanked: 0 time
- Been thanked: 0 time
by sbec » Wed Dec 14, 2011 8:11 pm
Hi,
I face a simular Problem here.
If i LIST or SELECT ADCOM
i only get Segment ADCOM back... I try to loop through all the Segemnts, but the 2nd one is already <BLANK> showing the End the the Data_Area
How do i get ADOP / ADDEP / ADRUN /ADSR Segments ?
Also with LIST ADKEY, i only get the ADKEY Segment back.
Regards
Sbec
-
sbec
-
- Posts: 3
- Joined: Wed Dec 14, 2011 7:50 pm
- Has thanked: 0 time
- Been thanked: 0 time
by sbec » Thu Dec 15, 2011 2:04 pm
Got the Solution:
1.st you do a List of ADCOM ADID .... then you Get VALFROM STATUS.....
2. You SELECT AD for this ADID VALFROM STATUS...in the AD you get all the Segments
Greets
-
sbec
-
- Posts: 3
- Joined: Wed Dec 14, 2011 7:50 pm
- Has thanked: 0 time
- Been thanked: 0 time
by BillyBoyo » Thu Dec 15, 2011 2:23 pm
Thanks for letting us know.
-
BillyBoyo
- Global moderator
-
- Posts: 3804
- Joined: Tue Jan 25, 2011 12:02 am
- Has thanked: 22 times
- Been thanked: 265 times
Return to Other IBM Tools